Before officially putting into production, debug the packaging machine, connect the power, turn on the control board power switch, emergency stop button, and check whether the display parameters of the packaging machine are normal.
Connect the air source and adjust it to 0.6-0.8kg/cm2.
Packaging box size adjustment: mainly adjusting the cardboard box rack, adjusting the box chain, and adjusting the length, width, and height according to the size of the cardboard box.
1. Place the cardboard box to be adjusted on the box seat, and adjust all directions of the box seat to the side next to the box. Make the box stable without falling.
2. Adjust the carton length: put the sealed carton onto the conveyor belt of the outgoing carton, and then adjust the right wheel to make the conveyor belt contact the edge of the carton.
3. Adjust the width of the cardboard box: First loosen the two sprocket screws on the main chain, and then place the cardboard box in the center of the chain so that its width matches the width of the box. The rear sprocket screws then lock.
4. Height adjustment of the paper box: First, loosen the two fastening screws of the upper pressing guide rail, then rotate the handwheel to make the upper guide rail contact the guide rail on the paper box, and then lock the fixing screws.
5. Adjust the size of the material slot: Loosen the fixed bearing screws, place the product in the push plate grid, rotate the baffle left and right until it is adjusted to the appropriate size, and lock the screws. Attention: There are several screw holes on the panel, be careful not to tighten the screws.
After each adjustment is completed, the inching switch on the control panel can be activated, and manual debugging can be carried out using inching operations, such as unpacking, suction, pushing, folding, spraying, etc. After installation, the startup mode can be turned on and twisted. After startup, the materials can be placed on the material conveyor belt for normal production.